? How to clean and dust the Antminers

Description

When should I clean and dust the miners?

1. When you find the casing of the miners becoming dusty.

2. When the miners are found to be not running properly due to dust accumulation or other debris attach on the hash board which affect the heat dissipation.

3. When you inspect the miner. Clean the dust regularly, we recommend doing it once a month

IMPORTANT: The miners must be shut down.

 

 

Equipment: Air Compressor + Air Gun

Air Pressure range: 0.7 +/- 0.05 MPa

 

 

How to clean and dust?

1. Use the air gun to gently blow the front and rear fans twice 

2. Put the air gun close to the fan, be careful not to touch the grille or fans blades  to prevent damage, blow every gap for 2-3 seconds and repeat the steps 2 to 3 times.

 

 

If the air gun cannot blow out the dust because of the high humidity (causing the dust to be stuck), you need to remove the fan and brush out the stubborn dust.

 

DGminer CryptoCurrency Service

Follow Us in these Social Network

 

           

 

 

9 February 2019
Viewed count: 118
Write new review

Reviews

All Categories
Manufacturers
Latest articlesArticles Archive...
The next generation mining hardware are FPGA 2 June 2019 18

Extracting digital currency was initially done by CPUs. Some time later, the GPU replaced the CPUs due to higher speeds and lower power consumption. GPUs are flexible in implementing various algorithms. Then, ASICs were used with the special application of extracting a particular high-efficiency algorithm. After them, FPGAs will be used.

Read More...
Visit Statistics
70
403
11384
49964
Your browser is Out-Of-Date!
Update your browser to view this website correctly. Update Browser Now
×